Airsoft Canada - View Single Post - Gas magazine leaking at the fill valve. How do I tighten it?

HelloKitty · September 11th, 2009, 16:11

I've tried spraying silicon on it and that helps slightly, but it still leaks.

1) Do I need a special tool to tighten that valve? I tried using a flathead screwdriver, but it doesn't seem to fit right, it's either too small or too large.

2) Where can I buy replacement o-rings? I went to the hardware store, but all their rubber o-rings are too large.

September 11th, 2009, 16:11	#1
HelloKitty Trader rating Join Date: Jul 2007 Location: CA, USA	Gas magazine leaking at the fill valve. How do I tighten it? I've tried spraying silicon on it and that helps slightly, but it still leaks. 1) Do I need a special tool to tighten that valve? I tried using a flathead screwdriver, but it doesn't seem to fit right, it's either too small or too large. 2) Where can I buy replacement o-rings? I went to the hardware store, but all their rubber o-rings are too large.