|
I have the FTK in my rifle with no problems, even with up to a 300% spring in it and a 12V batt.
I do not have a MOSFET in there though. Is your MOSFET made for the PSG-1 ONLY?
Is there some setting you have to go though to get it set up for the PSG1?
OR is it just a basic FET to keep heat off of the trigger contacts?
If its a more advanced FET, it could be getting confused by the way the PSG-1 works and not doing the proper full cycle(PSG-1's cycle is much longer then a normal AEG), that would explain the inconsistent pressure on the decocking lever.
Try taking the FET out and run the rifle without it for a few rounds and see if you get pressure on the lever, do this a few times just to make sure.
IF its not that, take the mechbox apart again and make sure nothing in the decocking system got messed up while the FTK was being put in.
|