Airsoft Canada - View Single Post - AWS Raptor motor stop before releasing the spring

Jughead · December 31st, 2011, 14:20

Hello Gents,

I didnt want to start a new topic, so I am adding to this discussion.

I have installed the Raptor and have checked the trigger travel length (good), I have checked that the cut off is fully engaging (good) and have also checked to make certain the selector plate is contacting the unit fully and that the section that was cut out was far enough (good).

But for some reason I only get safe-semi-semi.. Other than that it is working great..

Any ideas on what I can be missing?!

Does the selector plate spring need to break in for a while?!

December 31st, 2011, 14:20	#13
Jughead Trader rating Join Date: Jun 2006 Location: Edmonton Alberta	Hello Gents, I didnt want to start a new topic, so I am adding to this discussion. I have installed the Raptor and have checked the trigger travel length (good), I have checked that the cut off is fully engaging (good) and have also checked to make certain the selector plate is contacting the unit fully and that the section that was cut out was far enough (good). But for some reason I only get safe-semi-semi.. Other than that it is working great.. Any ideas on what I can be missing?! Does the selector plate spring need to break in for a while?!