Quote:
Originally Posted by Qlong
There is, I've developed a simple procedure which transfers the energy from recoil into the frame of the trigger pin hole rather than into the fastener post.
I'm just working on CAD which simulates the stresses on the post before and after the modification.
Preliminary testing proves successful as no signs of cosmetic fatigue or fractures along the surface of the fastener post on Frame #1.
I can't say much about Frame #2.
Preliminary tests done outdoors at 2.0 degrees centigrade on compressed air @ approx 110 PSI to exaggerate plastic behavior in the material.
Frames #1 and #2 on Left and Right respectively.
 |
So how about that tutorial? Ive been dying to do this to my glock.