|
You better just try to change you gear set to a higher torque setup, same for the motor. Them keep your packs at 9.6v... it REALLY is not good for the motors used in airsoft guns to run above that. (they are made for 6V is I recall correct...) Except for Sys's PTW... almost no gun can stand a 12v for a long time.
And you can't get high FPS AND ROF without having a lot of issues... I ran a P90 on a stock spring spitting at 30BB/sec..... (Li-Po 11.1V 25C pack made for racing RC) I had to change the gears and piston after 2000 BB....
It is "ok" to be able to pour a lot of bbs.... but you better be able to suppress the whole day a little less than 2 hours intensively....
anyways.... 10 bb/sec is PLENTY enought to keep the heads down... don't worry about that...
|