Aaaalright. I get my G&P RDS and railed gas block tommorow, and i've encountered a doozy of problems with my m16.
Heres the story so far.
I was able to grab an old TM m16a2 for 220 from a buddy of mine, It had a broken receiver tab (which turned to broken tabS) and a missing hopup bucking. So I purchased a Dboys metal body, Which ended up not fitting... So I filed down the top of the gearbox only a little bit to make it fit ( The spring for the T charging handle was colliding) and all was good. a few days after that, I received my Kings arms Metal hopup unit, which was installed soon after.
My problems:
1) Whenever i fire, it sounds like the inside of my gun is farting. I dont think my bbs are able to get past the hopup unit. like I had mentioned, the hopup unit was changed to a metal one peice. I'm thinking the problem is that the end of the hopup sleeve isnt pushed on far enough, i'll try fixing that tonight.
2) I can hear a 'vibration' noise inside of my gearbox. I took off my upper receiver and watched the gun fire, the guns spring is vibrating with each shot.
3) My fuse wire is pinched and seems to be blowing the fuse a lot, The negetive wire is pinched. I'm gonna send that out to be replaced. lucky I have a local battery shop nearby.
4) My motor starts to overheat as I fire, I think its because of the crunched negative wire.
Thats it for problems so far... I will list more as soon as I encounter more problems... Im sure i'll encounter more.
________
LovelyWendie