|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
October 25th, 2012, 22:29
|
#1 |
|
King Arms M4A1 Trigger Guard Removal?
Hey, all! Can anyone tell me how to remove the trigger guard on a King Arms M4A1 AEG? I can see a roll pin on the end nearest the grip but on the side near the magazine well, I can't tell what's holding it in. It looks like a screw but it doesn't take an Allen key or anything else I can determine. There's no hole on the other side so it can't be a roll pin either. Please help!
|
|
|
|
October 25th, 2012, 22:40
|
#2 |
|
The back roller pin (in front of the grip) has a taper and flat end. Use a 3mm punch to against the flat end and push it out the other side. If it does not have a hex hole, then it is a pin for sure.
The pin (near the mag well) is a set screw. Use a 1.5mm hex key to remove it. Last edited by SuperHog; October 25th, 2012 at 22:45.. |
|
|
|
|
October 26th, 2012, 00:11
|
#3 |
|
|
Thanks for the reply! However, after some exploration, it turns out it's not a screw at all but rather a spring-loaded pin. I just stuck a small screwdriver into the hole to push the pin down and it swung right out!
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
