Gas gun problem

[Geoffrey B.]

Hey,

Well I have been having some problems with my KJ Works m1911 lately. When I put the mag in and pull the trigger all the gas in the mag goes through the gun at once and out the barrel. I didnt try it again as it could freeze and o-ring or something. Is this the mag? Could it be lack of pressure?

[coach]

check the flow valve and see if it's sticking. the flow valve is not where you fill it but has a little button where the hammer strikes it. if it is sticking, you can try to give it a silly oil bath. there could also be something broken in the GBB itself. without seeing it it's really hard to diagnose.

do you know of a gun doc near you?

don't worry about an oring freezing when you vent a mag completely. it's not much of an issue. more so a waste of gas over anything. as long as you don't mess with it while it's cold, it should warm up and be fine.

[SlashH4X]

i sometimes have this problem with my KJW Hicapa and i usually fix it with oiling the magazine and gun with silicone oil. i would also reccomend you oil the hammer mechanism

[Geoffrey B.]

Thanks guys it was just the mag =) I put a TM mag in and it worked great =)