L96,vsr-10, a.s.r?

[TheAirsoftGhost]

Hey everyone, im planning on ordering a new sniper rifle and I was considering the UTG L96, UTG VSR-10, Echo1 A.S.R. Which one do you think i should go with? Also, if anyone has any of these guns please comment on how it is. Thanks everbody and Merry Christmas!!

[Amos]

None.

If you're going to get a bolt action get a name brand that'll preform well.

Tokyo Marui VSR-10
Tokyo Marui L96 AWSS
Classic Army M24

[ThunderCactus]

+1 and 10 other highly experienced people are about to post the same thing lol

[Doctorpepper]

I had a Ultimate L96 From Buyairsoft.ca, Its a amanzing sniper rifle and love it! im shooting .36 at 420 FPS on Stock Only thing upgraded was the trigger to a metal one its awesome and it was only 269$

[Strelok]

Originally Posted by Doctorpepper Airsoft NB

I had a Ultimate L96 From Buyairsoft.ca, Its a amanzing sniper rifle and love it! im shooting .36 at 420 FPS on Stock Only thing upgraded was the trigger to a metal one its awesome and it was only 269$

Nope.

Amos and Thundercactus have the right idea.

Don't cheap out on stuff. If you want the best out of your gun, buy quality.

[Saberwing]

Originally Posted by Doctorpepper Airsoft NB

I had a Ultimate L96 From Buyairsoft.ca, Its a amanzing sniper rifle and love it! im shooting .36 at 420 FPS on Stock Only thing upgraded was the trigger to a metal one its awesome and it was only 269$

I want to see a chrono of that... 420 with .36 stock?

I guess ignorance is bliss

[ThunderCactus]

Originally Posted by Doctorpepper Airsoft NB

im shooting .36 at 420 FPS on Stock

That's equivalent to 565fps on .20s

[venture]

Just do a little research and get a rifle that uses standard VSR10 parts or standard APS2 parts and you will have plenty of aftermarket parts to work with. The ASR will fit that bill. I believe it uses all APS2 parts.

[Curo]

Well you could get an Echo1 M28 but I mean thats a not bad but anything C-tac airsoft, UTG or ACM will give you an STI

[Reckless]

get a clone sniper rifle and replace EVERYTHING except the stock... which will cost you $1500+ MORE for all brand new parts worth buying (ebay, and used parts excluded) .... the clone bodies/cylinder/hop units are not to spec of the TM they cloned, and the aftermarket parts don't fit properly ... what this means is a cheap ass AEG with less then $50 in aftermarket parts will walk all over you

or spend a couple hundred more (if that once you factor stuff from the AV section here) for a TM or CA .. and put $500 into it and have a 300 foot death stick ....

[venture]

Originally Posted by Reckless

get a clone sniper rifle and replace EVERYTHING except the stock... which will cost you $1500+ MORE for all brand new parts worth buying (ebay, and used parts excluded) .... the clone bodies/cylinder/hop units are not to spec of the TM they cloned, and the aftermarket parts don't fit properly ... what this means is a cheap ass AEG with less then $50 in aftermarket parts will walk all over you

or spend a couple hundred more (if that once you factor stuff from the AV section here) for a TM or CA .. and put $500 into it and have a 300 foot death stick ....

This is where you need to do research if you wish to save $$. There are clones out there that will accept the TM and Maruzen standard parts. There are also clones that will frustrate at every attempt at upgrading.