416 inner barrel question

[Drache]

Simply put, what is the inner barrel length of a JG 416 with the crane stock? I need to know exactly for an upgrade I am planning.

[Styrak]

About a regular 363mm M4 barrel with 3cm cut off. So 330 mm.

[TokyoSeven]

Mine was under 300mm!
Dont ask my why because I dont know but it was nowhere close to the end of the outer barrel.

[Drache]

My inner barrel is within an inch to two inches to the outside of my flash hider. Styrak is that just an educated guess? I don't want to end up buying a barrel and have to worry about cutting it down or it being too short.

[Crunchmeister]

I would suggest that you simply remove the inner barrel from your 416 and measure it. That way you know for sure without any guesswork required.

[Qlong]

Mine was 285mm.

[AngelusNex]

Just measured mine at 260mm, aprox. 1 1/2 inches from the tip of the flash hider making it just the right length for it to look perfectly real.

[Drache]

Ok Im going to guess that these barrels are all different lengths then or something lol. I'll try pulling mine out tonight and measuring it up then.

[AngelusNex]

Lol... yeah JG is very very random when it comes to consistency in their product.

[Crunchmeister]

Yeah, it seems to be that way from all reports of JG guns. One example being the mechbox in mine. Everyone so far seems to report an SB-stamped mechbox, whereas mine is stamped UTG instead.

I was curious, so I just checked out my inner barrel. Mine runs the full length of the outer barrel right to the flash hider. It measures up at 288 mm.

[Styrak]

Originally Posted by Drache

Simply put, what is the inner barrel length of a JG 416 with the crane stock? I need to know exactly for an upgrade I am planning.

I cut off 3cm and it worked fine. Stuck out of the outer barrel a little, but not so much that you could see it through the cuts of the flashhider, viewing the gun sideways.