|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
October 5th, 2008, 01:14
|
#1 |
|
Metal body mods- help?
I need to cut off some parts of my metal body to fit the wires through for a G&P crane stock. Not just the part that holds the buffer tube but the rear end of the lower receiver because magpul didn't leave a space there at the back to allow a wire to go through.
 As you can see at the above picture, there is a space for wiring at the bottom of the tube for wiring but for my metal body, it's just round. There is no indent for wires. What tools do i need to do this modification? Thanks. |
|
|
|
October 5th, 2008, 02:41
|
#2 | |
|
a drill, drill press would be better and a dremel or an air grinder
__________________
JAYHAD: Commander - Airsoft Assassins distributing plastic death one nerd at a time JOC Age Verifier Quote:
|
|
|
|
|
|
October 5th, 2008, 02:46
|
#3 |
|
I just used a dremel, works well if you have a steady hand.....I had a similiar problem. If you look up "hk416 stock" posted by beach in this section it might help you out. Crunchmeister posted a helpfull link on their about this....
Cheers
__________________
Live for nothing, or die for something They can have my rifle when they can pry it from my dead cold fingers Last edited by BeAcH; October 5th, 2008 at 03:38.. |
|
|
|
|
October 5th, 2008, 03:04
|
#4 |
|
Well, I'm glad that the reply I posted was so helpful that it's being referenced.
This is the thread in question that I referred BeAcH to... http://www.airsoftcanada.com/showthread.php?t=60410
__________________
|
|
|
|
|
October 5th, 2008, 03:19
|
#5 |
|
|
Wow. THANKS ALOT! +1 respect
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
