Putting back together a TM G3.

[spacemoose]

Gentlemen,

I call upon your vast knowledge in helping me reassemble my TM G3.

Some time ago (months) I decided what fun it would be to take it apart and literally store it in a junk drawer (cause thats what it was)

With an on the job near death experience just recently come and gone I've felt a new zest for life and have begun taking on those projects I lazed out on over the years: Changing my car's oil, getting that STD test I needed 6 months ago and more relevant to this forum, putting together my junker G3!

As far as parts going back in the right places I'm doing just fine. My only problem is that most of the screws and bolts are missing and im quite sure I can't slap this together using contact cerement or chewing gum.

I have done the usual searches here on and gizzoogle, and have not been able to get much out of both. The owners manual I found on arnies airsoft helped a bit. Alas, im still confused.

I'd greatly appreciate it if anyone could send me the right direction with a idea of what screws/bolts i'll need and how many.


Kthnx.

[pipefitter316]

got a jg g3 good luck with yours wish i could help you

[pipefitter316]

i been dri8nking so im no good 2 jhelp you
merrry christmas to all

[spacemoose]

Originally Posted by pipefitter316

im no good 2 jhelp you

Yeah, I kinda gathered that already.

[Rainer]

http://www.e-gunparts.com/productsch...rModel=1570zG3

http://www.robertrtg.com/g3.html

Most of the screws, bolts, pins, ect. can be used from a original Real Steel HKG3. The top two sites are pretty good the second being used more recently by my dad to build a TM G3 similar to the one issued to him in the Bundeswehr. Exept for the receiver(which is a CA metal body), barrel(CA metal again), and obvious airsoft internals its 95% the real deal.