Canadian Forces 80's Pat Web Yoke ?

[FUK.NUT]

How does it Fit on im planning on getting one to replace my American Yoke but i was wondering if any one had any time to post some pictures to show me how Thanks


~FUK .

[Rifleman90P]

I spent 11 years in the CF and our team uses the 82 Pattern Web-Gear, so I'm quite familiar with it.

The Canadian 82 Pattern Web-Yoke is not compatible with the American web-belt.
You could adapt it, but they are not designed to work together. You're better off replacing your American yoke with another one, or switching entirely to a set of 82 Pattern Web-Gear.

To be more detailed in regards to how it fits, the yoke for the Canadian 82 Pattern Web-Gear, has four straps. The two in the back, have little plastic hooks which point in opposite directions (up and down) and clip onto the butt pack. The two in the front, have the same plastic hooks and clip onto magazine pouches, or the utility pouch. Obviously, the magazine pouches, utility pouch and butt pack all clip onto the web belt.

The straps from the yoke will not properly clip into the web-belt directly - and stay connected - they have to be connected to the pouches and butt pack. The spacing of the holes/eyelets that they clip into is different on the Canadian 82 Pattern web-gear, than it is on the American web-belt.

That's why I'm suggesting you go one route or the other, but not mix the two load bearing systems unless you're prepared to adapt one to the other.

Hope that helps!

Cheers!!
Brian

[Lerch]

http://www.freewebs.com/restigouche/...rn_webbing.pdf

The PAM for the P82 webbing.

[FUK.NUT]

Thanks Everyone for Helping it was a great help im goign to go find one now thanks again


~FUK