AK74 Selector

[Thenooblord]

I'm working on a CYMA AK74 and the selector is fucking with me, safe works, auto works, but in semi the trigger is locked, it seems the selector plate isnt moving to the right position, but all of the gears in the selector mechanism are meshing properly, any ideas

other than OMFG NOOB!!!

[Amos]

OMFG NOOB (lol)

You selector "gears" aren't lined up correctly, they jump when you put the box back into the body if you're not careful.

Also -- Sometimes if you don't run the wires correctly it can push things out of spec, re-check your wires and make sure everything is ran well.

[Thenooblord]

Originally Posted by Amos

OMFG NOOB (lol)

You selector "gears" aren't lined up correctly.

like I said, they are >.> I even tried lining them up *wrong* to see if I could get a different result, just made them worse

[Amos]

Originally Posted by Thenooblord

like I said, they are >.> I even tried lining them up *wrong* to see if I could get a different result, just made them worse

Yea I know, I updated my post lol, I was a little too hasty on my post, so I included some useful info.

[Thenooblord]

right now its out of the body and sitting on my desk, so the wires arent touching anything, I'm really at a loss, when i switch it to semi, the (cutoff lever? not sure of the correct terminology) moves into the groove in the bottom of the selector plate and blocks the trigger from moving, I can openly say, that its been MANY months since I've worked on an AEG, or even owned an AEG for that matter, I've been doing GBBs, so I've forgotten alot of shit lol, I'm not afraid to say it, but ive got no clue when it comes to the selector switches and stuff